Receiver 1.5mm JST Conversion Kit

Set consisting of three 1.5mm JST type female connectors and a 10cm transparent heat shrink sleeve.

These three connectors are designed for 1/28 scale chassis. In these chassis—Atomic BZ, AMZ, AMR, Ground Zero SZ, and GL Racing GLA—space is very important, so if you are using your own receiver, it is advisable to replace the standard connector of conventional receivers with these much smaller JST connectors.

ATTENTION:

If you do not have a suitable welder or the necessary welding knowledge, it is best not to perform these types of operations or to propose them to qualified technicians.

Once we have replaced the standard connectors of the receiver we are going to use with the JST type connectors from this set, we can either cut the original receiver box to make room for these small connectors, or use the receiver without the box, and use the heat shrink sleeve instead to protect the receiver's electronic circuitry.

The electronic micro speed controllers for 1/28 scale cars, as well as the micro servos that these chassis use, already work directly with JST connectors.