Plastidip Liquid Rubber Spray Bright Aluminum Effect

PLASTI DIP Spray Paint Can (400ml) in Bright Aluminum Effect color, in USA format.

The Plasti Dip paint pots called "Effects" have the same composition and characteristics as the basic Plasti Dip colors, and are designed to achieve different shades when sprayed over the basic Plasti Dip colors.

We cannot use Plasti Dip "effect" paint directly on the piece to be painted. First, we must cover the piece with the desired color from the Plasti Dip range (4 to 6 base coats).

This paint is used to coat objects and protect them from inclement weather (water), UV rays, etc. Once dry, it remains flexible and completely odorless.

It's waterproof.

Once dry, PLASTI DIP paints can be removed by pulling them off, as if they were a thin adhesive film.

We don't need to sand the piece or use any type of solvent for the paint removal.

PLASTI DIP liquid rubber forms a protective, rubbery layer, ideal for sealing, cushioning, and framing. It is also used as an anti-slip product. Especially recommended for indoor and outdoor use, it withstands extreme temperatures from -34°C to 93°C. It is also resistant to acids, alkalis, salts, oils, and numerous chemical agents.

It does not contain silicone and once dry, it can be easily removed.
Especially adherent to metals, wood, plastics, glass, fabrics, wool, stone, fiberglass or carbon fibers, etc. To increase its adhesion, you can use the primer product specially designed for Plasti Dip liquid rubber.

Instructions for use:

The surface to be protected must be dry, clean, and free of any substances that may hinder adhesion. Before opening the container and applying the product, shake gently and then open it. Let it rest for a few minutes to avoid air bubbles.

To spray it, we can use the Plasti Dip spray paint can, or the liquid paint can using PLASTI DIP solvent to dilute the paint.

To achieve a good finish when spray painting, we need to paint by applying thin layers (4 to 6 layers on average), leaving a minimum drying time between each layer, of about 6-10 minutes.

In this case of spraying, we recommend the use of electric spray guns (also called turbine spray guns).
Technical information on PLASTI DIP paint:

- Stable at temperatures between -34ºC and 93ºC.
- Optimal application temperature, around 20ºC.
- Minimum drying time upon contact: approx. 5 min.
- Complete drying time: 1 hour, depending on the thickness and number of layers applied.
- The manufacturer recommends layers of 0.2mm thickness, which will require 150gr of product per m2.

More information is available at: Uses of Plasti Dip with a shiny aluminum effect. Download the safety data sheet.