BZ2017 Front Camber Arm +0mm (1 pcs)(RC Atomic)

Original part of the upper front trapezoid , right or left, made in aluminum , with camber 0 ( fall), with caster adjustment, manufactured by Atomic, valid for the Atomic BZ 2017 chassis.

This trapeze replaces the original mounted as standard on the right or left side of the front axle of the Atomic BZ evo2017 chassis.

¿In what? affects the fall ( camber ) on the front wheels, to our chassis BZ evo 2017?

Although these upper trapezoids do not contribute negative fall to our front wheels, since they are trapezoids with camber 0 , it is important that we know in which they will influence. the camber to our chassis. The measure of the camber refers to the angle at which the wheels, in this case front, affect the track. When they strike without an angle, that is, perpendicularly, we talk about camber 0.

The adjustment of the falls, both in the front axle (as it also happens in the rear axle) will affect. to the lateral displacement of our chassis. Adjusting the falls, we manage to keep the largest wheel surface in contact with the runway, when we are in the middle of the curve, which is when the lateral displacement occurs.

When the car enters a curve there is a swaying of the chassis that will cause the wheels to work with a positive inclination or fall. Therefore, when we want to modify this situation, what we do is to adjust in advance a negative fall that allows us to counteract this effect produced by the roll and the lateral displacement of the chassis in curve, and that in this way the tread of the wheel is the maximum (more rubber in contact with the ground).

¿Using these trapezoids, can we adjust the caster address?

Yes. Along with this upper trapeze are supplied three small plastic washers that will allow us to adjust the degrees of caster of the front axle. We understand by caster or angle of direction or advance, the angle that form the vertical direction of rotation with the horizontal of the ground.

It is evident that changes in the caster setting also directly affect the direction response. To adjust the caster in this upper trapezoid we must use the washers included in this kit. We have three different degrees of caster depending on which orientation we put the trapeze (not symmetrical) and if we put the two washers behind the trapeze, or one in front and one behind.